Basic Information:
Printer Model: CR-6 se
MCU / Printerboard: STM32F103
klippy.log
Describe your issue:
I have a heavily modified CR-6 se that I was hoping Klipper could help me get running.
A friend said he could make I run better and followed this guide. How-to: The Creality CR-6 BIQU H2 Direct Drive extruder mounting kit | Sebastiaan Dammann
Except that guide is old and out dated. I tried for a long time to get proper firmware on it to get Marlin and community running.
I installed Klipper and heaters all axis work etc. My problem is that the z axis never triggers limit switch. This uses a strain gauge and I have doubts about if that is setup properly with the new direct drive head.
Can anyone point me in the right direction to determine if it is a hardware or software issue I am experiencing?