Help:Can't set up the stepper motor in the extruder slot

General Discussion
1

Basic Information:

Printer Model: custom
MCU / Printerboard: Octopus V1.1
Host / SBC BTT Octopus V1.1 + CB1 (SPI mode, external driver power at 48V)
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

I’m new to both printing and programming, and after a day of searching for information on setting up klipper, I couldn’t properly configure the fifth stepper on octopus.

please help me and explain why it doesn’t work.

…

printer.cfg (5.9 KB)

2

Hello @Fierfenix !

What problem do you actually have?
How do you know that the fifth stepper does not work?

Keep in mind that stepper 2 has two outputs.

Also: With stepper 4 and 5 the UART Pins do not fit to the other pins.

3

During the test to return to the 0 point, any motor that I tuned in driver 5 did not respond to commands and remained stationary

4

You swapped the UART pins with stepper 4 & 5.

Please verify.