Basic Information:
Printer Model: VORON 2.4
MCU / Printerboard: Octopus 1.1
Host / SBC: raspberry pi / EBB SB2209
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
On a new VORON build I am having an issue where when I set the temp on the Hot end the reading goes down as it heats up. At room temp the value is 160C. I am using the ATC Semitec 104NT-4-R025H42G thermistor.
…