Basic Information:
Printer Model: Voron 2.4
MCU / Printerboard: Octopus
Host / SBC Rasbpi
klippy.log
klippy.log (7.1 MB)
Describe your issue:
Hi guys
I’ve just fitted the new E3d piezo probe hotend, and i’ve come across an issue during quad gantry level, the probe is very sensitive and is still triggered at the end of a toolhead move as it tries to move down to probe the bed, so it’s cancelling out with a “probe triggered prior to movement” error.
E3D’s troubleshooting advises leaving a short delay between any horizontal move and probing, however I can’t seem to find any way to modify the QGL procedure in this way, do you have any advice or suggestions?
Thanks!