I have problem with "Move out of range: 0.000 0.000 5.000

General Discussion
1

I got some problem with my Klipper when trying to do a BED_MESH_CALIBRATE
Get “Move out of range: 0.000 0.000 5.000 [0.000]”
printer.cfg (6.2 KB)

Nead some help to solve this problem.

2

Hello @MickeD !

[bltouch]                               # enable for BLTouch
sensor_pin: ^PB1
control_pin: PB0
x_offset: -23.4 # -23.4
y_offset: -8 # -8
#z_offset: 0    
speed: 1.3

At 0.000 0.000, the BL-Touch is out of the bed.

You have to start at leat at 24.000 9.000 with the bed mesh. Better would be 25.000 10.000