Install Klipper onto Prusa mk3s+

General Discussion
1

Basic Information:

Printer Model: Prusa MK3s+
MCU / Printerboard:
Host / SBC
klippy.log
klippy.log (73.2 KB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…I have installed Klipper and Mainsail onto the Raspberry Pi 3b. I went through the ‘make’ etc but when trying to flash the board I get an error make no rule to make target flash.
Is there another way to flash the board with the Klipper firmware?
And also is there a source for the ‘printer.cfg’ file for the Prusa mk3s+?

Many thanks and much appreciated with any help

2

See How to: Klipper on Prusa MK3S/+

3

Thank you for your reply. I tried the website that you suggested but it seemed out of date as some links wouldn’t work. I looked elsewhere where I found a similar (Lab4450.com - Revive your Prusa Mk3s with Klipper 1/5 - Flash Bootloader), but it all went as detailed but still getting the same error!

IMG_0085
IMG_00853024×4032 2.91 MB

4

See Bootloaders - Klipper documentation → you should use the respective avrdude commands as also detailed in the links above.

5

Have you seen this? The configuration and instructions worked well for my MK3S+