I performed the skew compensation following the official klipper guide, and I was wondering if I could iterate the calculation with a new calibration print to further improve the compensation. From what I have seen, if I were to add a new set_skew it would overwrite the previous one, while if a calibration piece is printed with an active skew profile the measurements would be falsified.
For example, if I obtain a first value of 0.0009912, I expect the next one to be much smaller, for example 0.0001912, could I add it to the previous value?
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.