SKEW commands not working after upgrade

General Discussion
1

Basic Information:

Elegoo Neptune 3 Plus
MCU: stm32f401
`klippy.log
klippy.log (78.2 KB)

Describe your issue: Skew Commands not working after upgrade.

I ran the update manager and patched my os Ubuntu Server and updated Klipper and I think Moonraker. I’ve been working through SKEW calibration which requires prints measurements and adjustments and reprints to see if you can get closer to a perfect print. After the upgrades when typing into the Console SET_SKEW with the new parameters I get a return of Uknown command. Here is an example with another SKEW command to get the current profile.

Unknown command:“GET_CURRENT_SKEW”

Things were working before the last upgrade, and I was able to make SKEW adjustments. I’ve looked and don’t see any changes to the SKEW documentation for Klipper.

I;ve attached my klippy.log

Any ideas what might be broken?

Thanks
jv01

2

See G-Codes - Klipper documentation

You are missing the [skew_correction] config section.

3

I must have commented it out for troubleshooting. Then I had an issue with the extruder and had to rebuild the hot end so forgot I had done. Thank You very much for replying and for the catch. SKEW commands are working now that I have uncommented that section.

4

Hi, I’m just wondering if SKEW correction is worth doing? Be good to get people’s experience on this… I’ve actually printed and measured but cannot really understand the documentation. I failed to understand how to find and measure the XZ. can someone please point me to the right direction? Thanks

UPDATE: I’m running klipper