klippy.log
Hello everyone, I have a problem when moving axies on my printer.
I have a 310cm * 310cm as bed, but klipper, when moving axis by one, it multiply this value; and so, I can use only 150cm of my bed.
Why?
Here there’s the klipper.log if it can is helpful:
klippy.log (1.5 MB)
Have you checked for the correct jumper settings with the drivers for 16 microsteps?
Just a question. Why don’t you follow the scheme?
Printer Model:
MCU / Printerboard:
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
More info helps to help 
That’s my opinion.
Yes, the jumpers are connected correctly and microsteps are setting to 16.
If you are using TMC drivers, you should definitively add the respective setting blocks
Anyway, I adjust the microsteps in klipper configuration from 16 to 8.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.