Printer Model: Anycubic Kobra Neo MCU / Printerboard: Tri_Gorilla_Gen_V.3/ HC32f460 klippy.log klippy.log (43.7 KB) Trying to put klipper on my Kobra Neo. I’ve used kiauh to install klipper, moonraker, mainsail, and fluidd. When I go to the advanced section of the kiauh gui, then select “get …

Do you have a raspberry pi connected to the pins on the motherboard of the printer or do you have it plugged into the USB port? If you can SHH into the pi and issue the command ls /dev/serial/by-id/* That should give you the MCU serial port details you need to put into your printer.cfg file. ht…

I’ve done all of that. None of it works.

Thank you. Can you point me to where I can find info on calibrating dimensional accuracy in klipper as well?

Klipper on Anycubic Kobra Neo

General Discussion

Sineos September 27, 2023, 6:45am 4

This chip is not yet natively supported. See Support for HDSC chips (HC32F460) for a solution

Topic		Replies	Views
Printer is not ready The klippy host software is attempting to connect General Discussion	5	228	March 7, 2025
MCU problems installing klipper on S1 pro General Discussion	20	1364	September 9, 2023
Anycubic Kobra Neo - Connection issue General Discussion	47	850	April 25, 2025
Klipper issues installing/flashing General Discussion	12	2380	January 31, 2024
Klipper Cant connect to MCU ZNP Robin Nano DW V2.1 General Discussion	2	1332	February 5, 2024

Klipper on Anycubic Kobra Neo

Related topics