Klipper restarts mid print and canceling print

General Discussion
1

Printer Model: Ender 5 Plus
MCU / Printerboard:SKR 3 runnung ezdrivers
Host / SBC Raspberry Pi 3b+
klippy ender 5.log (2.8 MB)

klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…My first long print 13+ hrs on the new SKR 3 running ezdrivers
was completed no issues. Now any print longer then 4hrs will crash.Trying to see if it is the new SKR3 or the raspberry pi or just a bad setup. Any help is greatly appreciated.

2

The provided log does not indicate any failed print.

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.