Basic Information:
Printer Model: Creality Ender 3 S1
MCU / Printerboard:
Host / SBC: Rpi 3 A+
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
Klipper is shutting down in the middle of a print. Sometimes prints complete but sometimes they don’t. Logs are from a failed print and then a reprint attempt
klippy.log.txt (1.4 MB)
klippy.log (1).txt (2.7 MB)
afterwards.