Looking for printer.cfg for stock Ender 5 Plus using Manta M8P V2 with CB2

General Discussion
1

Basic Information:

Printer Model: Ender 5 Plus
MCU / Printerboard: Manta M8P V2
Host / SBC: CB2
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…I am looking for a config file to get the printer running again, I blew the stock motherboard and decided to upgrade instead of just replacing the original. I would like to eventually do the quad Z axis mod for auto leveling. But I need to get the printer working again to print the necessary parts. I have searched and searched but can not find a config for this printer in the stock state.

2

Hi @Orphan_Crippler ,

You can use a generic M8P config, like this one from BIQU:

Then, copy over the position_min, position_endstop, and position_max values for X, Y, and Z from the original config:

Make sure to select the right thermistor type for both the hotend and bed (from your old config).

1 Like
3

Thank you, I don’t know why I couldn’t find that second one you posted.