Lost communication with MCU ‘beacon’

General Discussion
1

Basic Information:

Printer Model: VORON 2.4
MCU / Printerboard: fysetc spider
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

I recently added a beacon as a bed sensor to be installed on the printer
I calibrated the probe and started printing, so it stopped not long after I started printing
Lost communication with MCU ‘beacon’ message popped up and shut down
However, I run homing and QGL and it’s up to bed mesh, but it always stops like this when I start printing
Beacon connection is soldered
Is anything wrong?
klippy (16).zip (2.8 MB)

2

The Beacon is:

  1. Closed source (at least its firmware)
  2. Not part of Klipper main line

You will need to reach out to the Beacon people for support.

3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.