Basic Information:
CR-10S Pro
MCU / Printerboard:
Host / SBC
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
Hello, I’m new here so please forgive any posting errors.
My question is about the M420 gcode command.
Specifically, is this a valid Klipper code? I have seen it added to my slicer’s machine settings in some machines and not others. Is it necessary or will it overwrite the bed mesh the machine performs prior to every print?
While on the gcode subject, is there a reference available that lists all pertinent Klipper-friendly gcode commands?