Basic Information:
Printer Model: Davinci 1.0 pro
MCU / Printerboard:Sam4e8e
Host / SBC Pi 4
klippy.log
klippy.log (10.2 KB)
mainsail doesn’t load? this was working earlier I just installed it directly from Pi Imager onto a known good SD card, I also tried a second SD card, I updated everything through Kiauh and still nothing? any guesses?
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
…