Printer Model: TLD3 PRO
MCU / Printerboard: INNOCUBE KLIPPER UPGRADE
Host / SBC ?
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
…
Hello @knowitallmom and welcome to the forum!
We have some requests:
Please a bit more information. Just the topic is not enough.
Please attach it to your next post.
Also, knowing the Host/SBC can help a lot too.
In all: How-To Ask for Help
Sorry, I did not realize this actually posted. As I was writing this post I was able to fix the issue so I just left the post. I am new to discourse and probably need some training on how it actually works. Thanks for the quick response. The fix was similar to another post I found on here with have 2 Z axis I needed to comment out the second one since I was using the probe on the first one. The other issue which occurred was the board mapping. The innocube boards I purchased are custom tweaked by innocube and I could not find any schematics for the 3 boards which made it difficult coding the pins in Klipper correctly. All is well as I was able to figure the issue out and get the bltouch working.
