MCU shutdown timer too close - on first move after homing

[Robotics]

I already did . I am pi 0 2w and my board is skr 1.4 tubo.

Mcu touches 100 and then came back to normal

Basic Information: Printer Model: MCU / Printerboard:SKR 1.4 TURBO klippy.log I am using Skr 1.4 Turbo with Pi 02W. I also attached the camera on USB. The system was working properliy . But I update the system yesterday. After update it crashes again and again. After that i format that card did the fresh installation of the klipper and all the things. All the things are working good. My CPU is around 3 or 4 %. But after 3 to 4 hours the system sutdown automatically . And most of time i se…