Mesh_min not specified

General Discussion
1

Basic Information:

Printer Model: QIDI Q1 PRO
MCU / Printerboard: ARM CORTEX
Host / SBC FLUIDD
klippy.log

ERROR
ERROR836×272 18.5 KB

moonraker and klippy logs.zip (3.7 MB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…This error occurred recently on my Q1 Pro. I performed a bed mesh calibration then home’d the unit before entering SAVE_CONFIG, then the error appeared. Klippy refuses to recognize the mesh_min values no matter how I format or punctuate the values. I tried powering on and off, even entering values from the oldest cfg files in the system and still no luck. Any help would be greatly appreciated!

2

BED MESH
BED MESH387×281 5.54 KB

3

Hello @MachiPro !

Git version: 'v0.10.0-530-g3387a9c2-dirty'

Besides the Klipper version is quit out of date, it is marked as dirty and we do not know what is modified. The "dirty" Flag and the Team's Position

Have you tried a pristine version of Klipper?

1 Like
4

I haven’t made any changes to the firmware. This is a Qidi Q1 and is probably marked as dirty due to their changes.

5

Unfortunately, this means the help we can give here is limited since we don’t know the extent of these changes and how they affect Klipper.

6

Thanks for the explanation. I reloaded the latest firmware and it’s back online.