Move only one motor, not an axis, and not stepper_buzz

Basic Information:

Printer Model: Custom
MCU / Printerboard: Manta M8P
Host / SBC: CB1

Describe your issue:

I have my printer configured and everything working ok. Neverthless, i want to move an specified motor, for example, for maintenance tasks in my printer.

For now, i just disconnect some motor cables, and command the printer to move the desired axis, in this way, only the desired motors will move. However, i prefer not to do this but do it via software.

Is there a way to do this?

I have tried to configure a manual_stepper in the same pins as my steppers and create a duplicate_pin_override section, but it doesn’t work.

FORCE_MOVE

Thanks a lot! @Sineos

It works perfectly.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.