Move out of range: 215.00 215.00 -21.390 [0.000]

General Discussion
1

Basic Information:

Printer Model: Elegoo Neptune 4 Max
MCU / Printerboard:
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

… I put the springs back on the plate and I’m trying to level the plate of my Neptune 4 Max but when I launch the print it makes a beep and the printer stops. On the Klipper Fluid console the writing Move out of range appears: 385.000 30.000 -19.930 [0.000]. I can’t understand what I should do.

2

Hello @Biellaintitanio !

Please attach the klippy.log to your next post.

1 Like
3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.