Basic Information:
Printer Model: Ender 5 Plus - 350x350x400
MCU / Printerboard: stock board & creality sonicpad
Host / SBC
klippy.log
klippy(2).log (46.6 KB)
printer.cfg (5.3 KB)
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
Move out of Range error, on theY350.030 and Extruder [400554.237] value. This happened DURING the print as it was about 75% done at the coordinates listed in the error code. Im not familiar with troubleshooting errors, but both Y350.030 & [400554.237] seem incorrect.
PrusaSlicer shows the bed limits are 350x350x400, so im lost.
[ERROR] 2024-10-22 16:39:49,468 [root] [virtual_sdcard:work_handler:1342] file:/root/gcode_files/OEM_ASA/303040_D234_8h9m_0.64mm_260C_ASA_ENDER5PLUS.gcode,error:{“code”:“key243”,“msg”:“Move out of range: 195.061 350.030 328.472 [400554.237]”, “values”:[195.061, 350.030, 328.472, 400554.237]}