V2.4 R2 with Klicky Proble. Doing Homing of all axis no errors occur. Doing QGL, Probe_Calibrate or Probe_Accuracy, all OK. Docking and undocking klicky proble also ok. If i press Bed_Mesh_Calibrate, the toolhead picks up the probe, goes to the center bed or park position and gantry starts to go…

You have to calculate the offset of the probe into the mesh boundaries. [probe] pin = EBBCan: PB8 x_offset = 0 y_offset = 25.0 z_offset = -10 speed = 10.0 samples = 3 samples_result = median sample_retract_dist = 3.0 samples_tolerance = 0.006 samples_tolerance_retries = 3 [bed_mesh] speed = 240 ho…

Yeap, Thank you. Problem solved. :+1:

I have the same problem and it does it when printing also. I have an Ender 6 I have installed a Revo Hemera with BL-Touch and I am getting move out of range errors when the extruder goes near the back of the build plate. Ender 6 bed is 250x250 but due to extruder change it is now 220x250. I have tri…

Hello @Dooley136 ! During print, it is no problem when the BLtouch leaves the print area. Except it crashes into something. Afaik, the x/y endstops with the Ender 6 are mounted to the rails. The bed size and the endstops are still the same even after the mod with the new extruder. Only the usable…

No I can’t move the extruder all the way to the front as the parts cooling fan is mounted to the front of the Hemera and hits the front rail hence the 220mm setting. I originally converted it to the Biqu H2 extruder and followed the 3d print beginner guide but found the extruder to be rubbish so now…

Tried your settings but got an error saying stepper x end stop position had to be within min and max. I changed them to this which works and the bed mesh calibration finishes with no errors now. The only problem I can see now is the bed mesh calibration seems alot smaller than the bed. Do you think …

Ok played with the bed mesh settings and got it perfect, now I just have to get the extruder homing to the center of the bed and it’s done. Thanks so much for the help I have included my printer.cfg in case it can help anyone else. printer.cfg (6.1 KB)

Move out of range when doing Bed_Mesh_Calibrate

General Discussion

EddyMI3D Split this topic December 31, 2023, 4:51pm 9

A post was split to a new topic: Move out of Range during Mesh Calibrate

Topic		Replies	Views
Always have Move out of range on bed mesh calibrate General Discussion	13	327	July 12, 2024
Calibrate after homing generates this error Move out of range: -22.000 -32.000 5.000 [0.000] General Discussion	3	842	February 3, 2024
Help with "Move out of range" General Discussion	7	522	September 30, 2024
Bed_mesh_calibrate move out of range General Discussion	2	175	September 28, 2024
Move Out Of Range Issue pls help - Bed Mesh Calibrate General Discussion	7	85	March 12, 2025

Move out of range when doing Bed_Mesh_Calibrate

Related topics