Basic Information:
Printer Model: Anycubic Kobra Neo
MCU / Printerboard: TriGorilla V_3.0.6
Host / SBC Raspberry Pi 3b+
klippy.log klippy.log (7.7 MB)
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
Hello Everyone.
i tried to get my Neopixel W2812 to work. but nothing happened.
i set up my Pi and .cfg correctly , i changed gpio ports, i tried to use a levelshifter but all i got is to light up 1 of 8 Neopixel but can´t change any color. i am at the end of my knowlage and need help.
to look if the leds work , i wired them to a Teensy board. so everything worked well. but i want to show the status of the printer with the led´s.
i hope anybody is here who can help me
thx