Basic Information:
Printer Model: Voron 2.4
MCU / Printerboard: stm32f407
Host / SBC raspberry Pi 3b
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
I tried to calibrate the first layer,using comand probe_calibrate,however some page should pop up asking me to adjust the Z-axis,noting appear.
So what can I do?
Is my file missing?Or there are certian steps I don’t know?