PID_calibration interrupted extrusor

General Discussion
1

Basic Information:

Printer Model: Original Hexagon 0.3 nozzle/self made
MCU / Printerboard:RAMBS 1.4 shield
Host / SBC: Rasberri Pi
klippy.log:octoprint.log
octoprint.log (158.0 KB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…

Hello

When trying to calibrate the PID for my extrusor, it stops at 65 Cº, this is the code that I use
PID_CALIBRATE HEATER=extruder TARGET=170

this is the error that i get

pid_calibrate interrupted

What could be causing this problem? Is it software or hardware malfunction?

2

Hello @thegreatjerk !

The template asked for the klippy.log, not the octoprint.log

Please attach it to your next post.

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.