Hello all guys, I’m in big troubles and i hope someone will help me. I’m unable to find which number set in the [bltouch] section in printer.cfg I get every time a "Unable to parse option ‘z_offset’ in section ‘bltouch’ error. here a part of my printer.cfg : [bltouch] sensor_pin: ^PE4 control…

Thanks a lot Sineos for your reply, I"ll post both files as soon i’ll be at home. Regards

Hi, Here my log and config. thanks for your help printer.cfg (1.8 KB) klippy(2).log (173.1 KB)

Your [safe_z_home] declaration has an initial space in it. Such declarations need to start in column 1.

@ [HotToddy] : Ok I make the change. Thanks to you

Upload : I’m still working and i found in moonraker.log that : 2023-01-24 19:15:05,665 [klippy_connection.py:_do_connect()] - Klippy Connection Established 2023-01-24 19:15:06,006 [klippy_connection.py:_init_klippy_connection()] - Webhooks Subscribed 2023-01-24 19:15:06,011 [klippy_connection.py…

I see too there’s no klipper service rening nor existing ?.. :face_with_open_eyes_and_hand_over_mouth:

Hi Barrus, your posts are a bit confusing. Why don’t you start describing your problem from the beginning. I don’t even understand what you want to fix.

@hcet14 : You’re right, i will close this topics and start a new one after reinstall mailsallos (if i meet the sames problems)

Pin number Bltouch CR10v2

General Discussion

Sineos January 23, 2023, 7:03am 2

Please attach your klippy.log and printer.cfg

Change mainboard CR10v2

Topic		Replies	Views
Z_offset not accepted in printer.cfg General Discussion	4	6522	May 10, 2024
Trouble adding in BLTouch General Discussion	6	3063	May 10, 2024
Unknown command:"TESTZ" General Discussion	20	5053	May 10, 2024
SAVE_CONFIG section ‘bltouch’ option ‘z_offset’ conflicts with included value General Discussion	16	658	March 26, 2025
Pin alias error when setting up BLTouch General Discussion	11	1076	May 5, 2024

Pin number Bltouch CR10v2

Related topics