Basic Information:
Printer Model:
MCU / Printerboard:
Host / SBC
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
… I currently have 2 ender 3’s. 1 is working with SKR MINI e3 v3, klipper and Pi4. The other will be the master ender, as in all the tests that I am currently working on are tested on the running ender 3.
The master ender will have dual z, linear rods (hopefully in all axis’s), klipper from the other ender, SKR MINI from the other ender, Pi4 from the other ender, and PrEnder .
This basically takes the MK3S extruder and puts it on the ender 3. It is currently on thingiverse.
My problem is the vague instructions are what I am assuming marlin.
How would I set up the Prusa MK3S+ pinda wiring, esteps , etc, to get this working on Klipper?
