Basic Information:
Printer Model:
MCU / Printerboard:
Host / SBC
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
new install and new user printer ender 3 s1 with sprite extruder. I got it all working and did z prob and bed mesh and notice in bed mesh everything was offset to the left and when I do the print its not center. I have seens all the other print not in center and started messing with max position and end stop and stuff to the point it gave me a error when I bed level and prints almost to middle but still off and im lost. I have attached screen shot of error and klippy.log and my printer.cfg
…
config-20251022-073953.zip (2.5 KB)
klippy.log (3.8 MB)