Printing prime line off bed

General Discussion
1

Basic Information:

Printer Model: Ender 3 V2
MCU / Printerboard:Linux Mint/Creality 4.2.2
printer.cfg (10.9 KB)

Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…
Evening All,

I’ve dialed everything the way I want far as bed mesh and bed size. I think I have it right, but for some reason my Prime line is printing off the bed. my x and y overall bed size is larger than the manufacturer advertized, but I did this to get as much additional bed size for better probing and printing area. Please see my config attached.Any help is appreciated.
Thanks!
Nino

2

It sounds like its priming outside your print area. You have your mesh at 244(x) and 241(y). Your Y offset is 21. Y-offset(21) + your bed mesh max (241) = 262.

3

Can you attach your Klippy.log file please, as per the instructions when posting an issue. Much appreciated.

2 Likes
4

klippy (10).log (1.4 MB)

Hey so sorry for the super late reply. I’ve made a few small changes, but still am experiencing the same thing. I’ve removed the prime line in klipper, however, have it in Orca slicer, which works out well, however, when printing an Ender 3 v2 bed level test, my print goes out of range and stops. I’ve attached my klippy log and have mirrored the bed size in orca as I have it in klipper. Thanks again!
Nino

5

To repeat:

6

klippy (10).log (1.4 MB)

I swear I just did in my previous comment. Here it is again though :).

7

Sorry. Overseen :blush:

1 Like
8

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.