I use a Creality Ender 5 S1 and I have been having frequent bed levelling issues. The only time I get a really good print is if I reset Klipper to factory default settings and go thru the process of setting up my printer. Now during this setup process, at the probe levelling stage (followed by manua…

Hello @DreamWalker ! For problems, issues etc please use the subforum: General Discussion. Can you please share the klippy.log?

Attached is the Klippy log and the printer config klippy.log (13.6 KB) printer.cfg (6.7 KB)

Could it be that you run the Creality Sonic Pad?

Yes… Sorry I did not mention that earlier

Then you may notice this: [image] Creality Sonic Pad and Alternatives Knowledge Base Creality Sonic Pad exclamation Update Since July 11, 2023, Creality seems to have released a firmware with a newer Klipper version. Again, they have not released the source…

This approach would be very really risky given my very limited knowledge of 3D printers.

Probe Calibration reset

General Discussion

EddyMI3D June 30, 2023, 5:49am 6

Then you may notice this:

Topic		Replies	Views
Probe_Calibrate does not function correctly or within a normal range? General Discussion	8	3293	April 28, 2024
Probe_calibrate generating negative number General Discussion	2	2010	January 4, 2023
Yet another z-offset question, odd setup General Discussion	3	137	November 7, 2024
Calibration z offset General Discussion	9	1323	December 30, 2022
Bed Probe Offset- How does it really work? What I've learned General Discussion	4	3641	November 4, 2022

Probe Calibration reset

Related topics