Proforge 3 with single extruder, SD CARD BUSY error

General Discussion
1

Basic Information:

Printer Model: PROFORGE 3
MCU / Printerboard: BTT SKR2
Host / SBC: Ubuntu LTS 20
klippy.log (124.2 KB)

klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…

Its a gifted Single extruder core xy (PROFORGE 3) that for whatever reason, when I try and print something it gives me 3 errors, “extruder” not hot enough, SD busy, Unknown command:“T0”

Im assuming its something in my printer.cfg but I honestly dont know.

Big thanks in advance if you even read this

EDIT**

This exact issue has been resolved. it ended up being a Gcode that was in my start gcode config settings. I pulled it out. No more SD_BUSY error.

But now I have different problems hahah

2

Hello @Jimmy_the_Cow !

Noice!

Then I recommend to open a new thread with the description of the new problem.

To handle that in this thread could become quite confusing.

1 Like