Programming question for the wizards of klipper haha

General Discussion
1

hey the klipper wizards!!

I have embarked my self on a stupid quest, I have so many printer parts laying around and boards now, I decided why not build a small cnc engraver/cutter…… now I have designed and printed majority of what’s needed other then the 20x40 stuff and now have a roughly 24inch by 20inch cnc the problem is I didn’t stop to think about programming boards.
So my question is this;
I have one btt mini e3 v3 board I’d really like to use for this or I do have a board from a Cr10s pro v2 which I believe is a 4.2.2 maybe a4.2.7? It’s not marked anywhere.

Regardless do any of you wizards know of a klipper flavour I could use to do this? Or what suggestions may you have?

Thanks again!!!

2

That should get you every piece of info needed. I would use one of the options listed and adjust to your cnc requirements.

3

Thank you I missed seeing this thread in my search.

4

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.