Basic Information:
Printer Model:
MCU / Printerboard:
Host / SBC
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
Not an issue, just asking to be shure I have the facts right.
I have two printers. A Voron 2.4 with a toolchanger and I just finished my SaladFork(mini Trident from Printer for Ants), both using classic Klicky-Probe. This means that the probe is offset from the nozzle. Now, from the begining, my Voron vas build with Klicky-Probe, so I dont have annother refference point.
What I noticed on my Voron is that the bed mesh takes into account the probe y offset, but QGL does not. I made marks with a marker on the buildplate for the probing points for QGL and bed mesh. For QGL the probing points(when doing QGL) are under the nozzle, and for the bed mesh are under the probe. The same now with my SaladFork with Z-Tilt and bed mesh.
Is this ok, or am I doing some settings wrong?
PS the log is from my SaladFork.
klippy.log (64.9 KB)