MCU / Printerboard: Raspberry pi pico
I tried to use the Rpico and connect a stepper motor to it but when I turn on the motor power, the rpico disconnects… does the pins have something to do with it? klipper does not report errors to me
More information would be quite helpful.
- The klippy.log (please attach it to your next post)
- How did you connect the stepper to the pico.
- What stepper driver do you use
2 Likes
Conexions:
Step: gpio4
Dir: gpio5
Enable:gpio6
(I did not find any nomenclatures for the pins of the raspberry pico, that is, like in Arduino the digital pins are PB4 etc. so I assumed that they were all gpio and their numbers and klipper did not give me an error)
It is very possible that that is where the error comes from.
I’m not at home right now so I don’t have the log.
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.