Struggling like hell with this. SAVE_CONFIG section ‘bltouch’ option ‘z_offset’ conflicts with included value I dont have any seperate .cfg files and save_config wont update my printer.cfg with the “do not edit below this line” This is my second klipper installation on this machine, i have an e3ma…

Hello @lukabert ! There is no SAVE_CONFIG section in your printer.cfg.

It wont auto generate. If i tun save config it throws up that error

Tried this last night. I dont have any .cfg other than my printer.cfg and inputshaper.cfg which is commented out. Going crazy with this. Is there a workaround to get klipper to rrcognize a minus z offset value?

Please attach a recent klippy.log and try removing the comments on: x_offset: -50 # modify as needed for bltouch location y_offset: -9 # modify as needed for bltouch location z_offset: 0.0 # modify as needed for bltouch or run P…

apologies for the delay in the response and thank you so much for your help so far. So i created a new printer.cfg and its still throwing up the same error. I dont have any include commands in my printer.cfg and i dont have anywhere to pull them from in my directory. I have included a klippy log …

Please always post the complete and unmodified log. Use zip if too big.

klippy log full.txt (544.3 KB) Apologies, i assumed the excerpt would have sufficed

I became a bit blinded. I was trying to be lazy and use probe_calibrate to set my z offset using the bl touch. Its not ideal but i can set it manually, as long as my printer has its functionality i can live without probe_calibrate

[grafik] try removing the blanks

SAVE_CONFIG section ‘bltouch’ option ‘z_offset’ conflicts with included value

General Discussion

Sineos January 7, 2025, 6:00am 4

See SAVE_CONFIG section 'bltouch' option 'z_offset' conflicts with included value

Topic		Replies	Views
Unknown command:"TESTZ" General Discussion	19	5254	May 20, 2023
Z-offset saving but not changing nozzle heigth General Discussion	18	866	October 21, 2024
Klipper reports: ERROR Option 'z_offset' in section 'probe' must be specified General Discussion	7	1464	September 28, 2024
SAVE_CONFIG section 'bltouch' option 'z_offset' conflicts with included value Knowledge Base	0	10910	February 13, 2023
Z Offset. Im going CRAZY! General Discussion	17	1674	June 25, 2024

SAVE_CONFIG section ‘bltouch’ option ‘z_offset’ conflicts with included value

Related topics