Hello longtime marline user here, really want to try out klipper but I have spent 10+ hours on getting my SKR mini e3 V 1.2 klippy.log (17.8 KB) to function! I have attached a log of my skr using klipper v0.1.0. When using the firmware made from this version of klipper with and without swd enable…

You’ve entered the wrong pin to set at microcontroller startup. Your screenshot shows pin !PA13, but it should be !PC13 per the instructions at the top of the standard config for that board. https://github.com/Klipper3d/klipper/blob/master/config/generic-bigtreetech-skr-mini-e3-v1.2.cfg

Okay, I will give this a shot! If it was really that simple of a mistake ill be really embarrassed… Thanks again.

Still working on the setup (been having various install issues) but I can confirm I had simply over looked the pin about a 1000 times! Thanks you are a lifesaver the pi now sees my board with the current firmware.

Just got my printer to successfully move! If you would be so kind would you point me in the right direction for settings I should change/ add? I’m currently using the example config and am customizing it for a cr-10 with a smart filament sensor. Thanks again!

SKR Mini E3 V1.2 Breaks USB detection after V0.9.0

General Discussion

jakep_82 April 18, 2022, 10:35pm 4

If that pin is misconfigured, USB communication won’t work. That is more than likely your issue.

Topic		Replies	Views
No MCU found! BTT SKR mini e3 V3 General Discussion	15	1185	April 5, 2025
SKR mini e3 v2 Not found after update General Discussion	12	4100	October 31, 2021
MCU unable to connect BTT SKR Mini E3 V1.2 General Discussion	20	2247	October 14, 2023
Klipper/Host can't find serial ports after firmware restart General Discussion	3	1156	September 22, 2023
SKR Mini E3 V3.0 MCU problems General Discussion	7	6692	April 25, 2023

SKR Mini E3 V1.2 Breaks USB detection after V0.9.0

Related topics