SKR MINI E3 V3.0 bl touch failed to retract probe

General Discussion
1

Basic Information:

Printer Model: cr-10 s5
MCU / Printerboard: SKR MINI E3 V3.0
“printer (6).cfg (6.3 KB)”

…
bl touch failed to retract probe(((
The printer does not go to the middle(((

I don’t understand English well, but I hope someone will help :slight_smile:

2

Honestly, if you have a ready-made firmware for “cr10s5” I would be glad if you shared (sonicpad)

3

Hello @slator_we !

You may take note of this:

4

I am having the same issue. Creality is no help.
Printer Model: Ender 5 Plus
MCU / Printerboard: SKR MINI E3 V3.0
BL Touch was wired incorrectly from out of the box and fried my other motherboard. I purchased this today, and now it will not auto-home. I’m hoping there is a problem with my config file, but I can’t find anything. I have a pi already and do not want to buy a sonicpad.

This is my config:
[bltouch]
sensor_pin: PC14
control_pin: PA1 # Format is: [!] [chip_name:] pin_name
x_offset: -46
y_offset: -7
z_offset: 10
speed: 2
samples: 2
pin_up_reports_not_triggered: True
pin_up_touch_mode_reports_triggered: False