Hi, I tried replacing the X/Y stepper with a 0.9 degrees (400 steps). Unfortunately, it is terribly noisy compared to a stepper of 1.8 degrees (200 steps). Configuration for 1.8 deg [stepper_x] step_pin: PA0 dir_pin: PC15 enable_pin: !PC11 microsteps: 16 full_steps_per_rotation: 200 rotation_dis…

Hi everyone. I will probably end this discussion, because choosing one 0.9 stepper from many variants so that it is not noisy seems to me a bad solution. I stay with stepper 1.8 where these problems are not.

Stepper 0.9 deg - very noise - Page 3 - General Discussion

Topic		Replies	Views	Activity
TMC Adaptive Microstep Table Developers	32	3975	January 21, 2025
Y axis more noisy/vibrates then X (TMC2209) General Discussion	30	1147	May 5, 2024
BTT TMC5160 PLUS tuning parameters General Discussion	46	5282	August 23, 2024
Motion analysis by stepper phase Developers	22	5213	May 26, 2024
Nosiy stepper motors General Discussion	9	365	April 26, 2025