Steppers just vibrate when trying to home

Basic Information:

Printer Model: ender3v2
MCU / Printerboard: BTT manta ez3 v1 / cb1 v2.2 , 2209 drivers
config-20240923-124027.zip (1.3 KB)

video of issue
Hyperlink for Video of issue

Describe your issue:

I have my printer- setup with klipper and mainsailos. im not getting any errors in mainsail but when i try to home a stepper motor, the stepper just vibrates.

Hello @seanc18 !

Please attach the klippy.log as it was asked for.

(Deleting the lines that ask for it does not free you from it)

2 Likes

It sounds like the stepper phases are not properly connected to the board.
Do you have the data sheet of the used motors and can check the pinout of the motor connector against the board connectors?

apologize i thought it was in the zip file.
klippy (17).log (28.7 KB)

i did remove the max accell decell

klippy (18).log (2.0 MB)
here ya go

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.