Suddenly no connection

General Discussion
1

Basic Information:

Printer Model: Aquila D1
MCU / Printerboard:
Host / SBC
klippy.log
klippy.log (753.0 KB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…I came to connect to the printer this morning and Mainsail just kept saying that Klipper couldn’t connect to the mcu? It was fully working the day before! I issued a ls /dev/serial/by-id/* and it shows a connection so it isn’t a cable error so I’m not sure what’s going on?
Any advice would be greatly appreciate

2

I think it’s now sorted

3

Would be nice to tell the community what the issue was.

4

Hi Eddy, to be honest I rebooted the host which sorted the problem out, so I don’t know what the problem was

1 Like
5

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.