Basic Information:
Printer Model: Endorphin3D Ender 5 MCU / Printerboard: BTT Manta E3EZ Host / SBC: BTT CB2 klippy.log
Hi everyone,
I’m new when in comes to 3D printing and this is my first conversion project,I’m trying to mod my Ender 5 Pro with the Endorphin3D an i’m at the last steps, all of the parts were printed with an SKR mini e3 v3 and i wanted to upgrade to a manta E3EZ but now that i’m trying to home the printer for the first time i get:
“Unable to read tmc uart ‘stepper_x’ register IFCNT”
For all the steppers (except for the extruder but it is on an EBB36)
This i a list of what i’ve tried:
Plugged the motor power to the PSU
Changed the jumper position from motherboard power to psu power and back
Swapped the drivers around to check for faulty ones
Replaced the drivers (3 of them) with newly bought ones
Swapped Cables
Swapped Motors
Tried STEPPER_BUZZ with all axis, all caused the printer to shut down with the same message (Obviously the “stepper_x” changed to y and z)
The only thing i haven’t done is swap the motherboard…
Anyone has some advice?
Thank you in advance
klippy-3.log (1.4 MB)