Basic Information: Printer Model: Ender 3 v2 MCU / Printerboard: STM32F103 klippy.log OctoPi: v0.18.0 OctoPrint: v1.8.4 Fill out above information and in all cases attach your klippy.log file. Pasting your printer.cfg is not needed Describe your issue: I have a new Klipper installation that…

I’m not yet loading a gcode file to attempt to print (can’t load it until after connecting), so I’m not sure where non-ascii characters would come from. I receive this error while trying to initially connect and it seems the only gcode sent is N0 M110 N0*125. I checked this output from the terminal …

Post you original printer.cfg Remove any gcode under GCODE scripts

I had GCODE scripts in “After print job is cancelled”, “After print job is paused”, and “Before print job is resumed” in OctoPrint and have removed them. I still receive the same error afterwards. I’ve attached my printer.cfg file, which is just of copy of ~/klipper/config/printer-creality-ender3-v…

I’ve discovered my issue. I had the MeatPack plugin installed in my OctoPrint instance. After disabling this plugin, I’m able to connect successfully. Thanks for your help @Sineos .

UnicodeDecodeError in gcode.py [New Install]

General Discussion

Sineos October 8, 2022, 7:07pm 2

See Help virtual_sdcard dispatch - #2 by Sineos

Topic		Replies	Views
Klipper Error : 'ascii' codec can't decode General Discussion	22	5826	February 25, 2023
Once printing is complete, Klipper turns off General Discussion	1	122	March 9, 2024
Despite following the guide on the Klipper docs perfectly, it is unable to connect to my printer General Discussion	18	2389	December 3, 2023
Bug with Cyrillic in gcode comments General Discussion	7	303	March 4, 2024
Flashing Klipper on stock Ender-3 General Discussion	4	162	January 20, 2025

UnicodeDecodeError in gcode.py [New Install]

Related topics