Basic Information: Printer Model: Voron 2.4 350 MCU / Printerboard: BTT Octopus Host / SBC: Raspberry Pi 4B klippy.log Hello everyone, I’ve been having issues with my Voron 2.4 for a while now. It keeps losing connection to my toolhead board (EBB36), which runs over CAN bus. Currently, the…

[image] mykepredko: – I looked at “caselight.cfg” and there’s no loading of led_effects.py. I’m not sure wat XOL_leds.cfg is, I couldn’t find it in a Google search. This is the config for the two nozzle leds with a lot of led_effects in it. [image] koconnor: So, ultimately, in this parti…

[image] Kridi88: Can I help with this? What do I need to do to make it possible for you to test it? This would need reproducing the same unwanted behavior without including any unofficial third-party modifications.

@MarcoCasarin Don’t hijack somebody else’s thread. Please start your own General Discussion query.

Okay, I’ve been printing with PLA and PETG all day. Yesterday I tried printing with ABS, lost connection to can0 again… There are still no LED effects for my nozzle LEDs. For high-temperature materials like ABS, I use four bed fans to heat up the chamber. Maybe the PSU is also a problem? After th…

@Kridi88 [image] koconnor: If someone can reproduce the issue on unmodified code I’ll take a look. [image] Sineos: This would need reproducing the same unwanted behavior without including any unofficial third-party modifications. Since you are quite new here. Do you understand the req…

In the Esoterical’s CANbus guide, he writes in the Getting started section ( https://canbus.esoterical.online/Getting_Started.html There is a known issue with Raspberry Pi operating systems where ‘Bullseye’-based distros (version 6.1.something) and 64-bit systems can cause very strange timing issues…

Well, I lied. Klipper is already dirty because of the cartographer. But that’s something i need… The print wasn’t going to work either: klippy(30).log (2.3 MB) :sob:

When you look at your log: The communication gets unstable around 8 seconds before the crash, with a rising error count and invalid bytes Invalid bytes usually point to serious errors, like hardware issues or being caused by kernel bugs in versions below 6.6

I’m on version 6.12 now. I just had a crash as I logged into the Pi through SSH to send the command “uname -a”. Could my Pi be the problem? klippy(32).log (7.3 MB)

Voron 2.4 CanBus: Lost Communication to mcu (EBB36)

General Discussion

hcet14 August 1, 2025, 3:47pm 44

@Kridi88

Since you are quite new here. Do you understand the requests from the guys above to be able to help you?

You may read here https://klipper.discourse.group/t/the-dirty-flag-and-the-teams-position.

Topic		Replies	Views
Issues with CANable General Discussion	64	6401	May 4, 2024
New Voron instance lost communication with EBB (can bus) General Discussion	29	1162	May 28, 2025
Chasing Missed digital out event General Discussion	56	443	July 4, 2024
Problem with CANBUS during print/idle General Discussion	81	8821	December 6, 2024
USB CAN is down troubleshooting help General Discussion	20	495	January 14, 2025

Voron 2.4 CanBus: Lost Communication to mcu (EBB36)

Related topics