Voron 2.4 Move out of range z?

General Discussion
1

Basic Information:

Printer Model: voron 2.4
MCU / Printerboard: octopus
Host / SBC rasp pi 3+
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
klippy (1).log (820.9 KB)

Describe your issue:

Tried printing and got this error I did the whole g28 quad gantry level then g28 calibrate_z_endstop, on a 100degree bed with 245hotend etc. Still having this issue.

!! Move out of range: 3.000 3.000 -5.295 [0.000]
22:30:11
!! Move out of range: 3.000 3.000 -5.295 [0.000]
22:30:11
!! Move out of range: 3.000 3.000 -5.295 [0.000]

Slicer Is cura “print_start” and “print_end” lowercase Im using a 0.6 nozzle and I just recently changed to a abnoob afterburner upgrade Not sure if after 10 prints in abs it changed something that changed the cura slicer?. I raised safe z height by 10 because my klicky probe was just smacking the bed and failing to grab. I also upgraded the bed by putting silicone rtv around the edges of the silicone heater bed, Made sure not to disrupt the area where screws are.

2

FIXED followed voron design guide, my bed mesh was messing with my z calibration! Initial Startup | Voron Documentation

1 Like
3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.