Basic Information: Printer Model: Voron 2.4r2 MCU / Printerboard: BigtreeTech STM32F446 klippy.log klippy.log (141.9 KB) Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “…

According to your last log, Klipper started up successfully. Maybe you have the wrong path setup in Octoprint. Try /home/Yuriy/printer_data/comms/klippy.serial

Voron can't connect to OctoPrint

General Discussion

Sineos November 12, 2023, 7:45am 5

The command ls /dev/serial/by-id/* will give you the correct path

Topic		Replies	Views
Klipper Internal error during connect: [Errno 19] No such device General Discussion	18	3680	May 26, 2024
Octopi won't connect with new Klipper install General Discussion	5	209	October 13, 2024
After upgrade mcu Unable to connect General Discussion	3	639	December 22, 2023
Newbie- can't flash klipper on octopus for voron 2.4 General Discussion	6	1132	December 4, 2023
Unable to get printer to connect to klipper General Discussion	15	172	June 6, 2024

Voron can't connect to OctoPrint

Related topics