Printer Model: taz 6
MCU / Printerboard: octopus 1.1
Host / SBC BTT Pi 1.2
crowsnest.log
crowsnest(1).log (6.7 KB)
After switching sdcards and reinstalling klipper w/backup printer.cfg. The webcam only shows a frame every 10-15seconds on the stream, not live video. fps counter is around 15. Tested the cam and nothing wrong with it.
Could you test mode: camera-streamer and restart Crowsnest?
How high is the load on your SBC?
camera-streamer has the same results, cpu peaked at 35% for a sec, avarage ~14% load
What if you reduce the FPS to 10 in the config and in MainSail?
no change. at 10 fps, 5fps is slightly better. Load @ 1.3
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.