Coming down the home stretch in migrating from Marlin to Klipper. I’m running a BLTouch, installed and working correctly. Trying to set the Z_Offset parameter. When I enter “PROBE_CALIBRATE” in the terminal window, it moves to the center of the bed (roughly), runs a probe cycle, then goes up ab…

X axis drift during "probe_calibrate"

Sineos November 7, 2024, 3:18pm 2

1 Like

Topic		Replies	Views
BLTouch looses config General Discussion	6	1110	May 10, 2024
Use probe to set z offset? General Discussion	13	1571	January 29, 2024
Klipper on mainsailOS probe calibrate and z offset General Discussion	3	2553	May 10, 2024
Move out of range while moving Z for PROBE_CALIBRATE General Discussion	2	6438	January 22, 2022
Probe_calibrate results in negative number General Discussion	18	6860	October 6, 2024