Basic Information: Printer Model: Voron 2.4 350mm MCU / Printerboard: Leviathan Host / SBC 4b klippy.log don’t seem to have one anymore??? Describe your issue: … I am trying to configure tapchanger/stealthchanger and when homing, it won’t move X past 300. It will go Y 350, but won’t fin…

Unfortunately, it seems this Klipper is heavily modified with 3rd party changes. Either roll back the changes and demonstarte the issue with an original Klipper or revert to the respective author of these modifications. From a “pure” Klipper perspective the x-axis is correctly defined with a range …

The base install of klipper is standard, I have installed a single add-on, which is KAMP, plus the necessary toolchanger software. What modification has been made that you believe makes this unsolvable? I might note that everything worked fine before I started modding for toolchanger. The printer …

[image] happyfunperson: plus the necessary toolchanger software. Untracked files: klippy/extras/bed_thermal_adjust.py, klippy/extras/multi_fan.py, klippy/extras/rounded_path.py, klippy/extras/tool.py, klippy/extras/tool_probe.py, klippy/extras/tool_probe_endstop.py, klippy/extras/toolchanger.…

[image] Sineos: klippy/e So you won’t help because it is a toolchanger?

We won’t help because some 3rd party modifications are altering Klipper’s standard behavior and we do not support 3rd party modifications. There are basically endless such modifications somewhere in the www. Some of decent quality, some of terrible quality and a lot in between. Unless somebody is …

I am using the good old standard stealthchanger and its instructions for toolchanger/tapchanger and nothing more than that Look, where might I want to search for conflicts that would fool the printer into thinking the bed size is smaller during homing? Or how would I check to see what size the prin…

I am not getting past this in homing_override so I don’t think it is the macro, I tried it with and without the line I added [homing_override] axes: xyz gcode: RESPOND TYPE=echo MSG='INITIALIZE TOOLCHANGER' INITIALIZE_TOOLCHANGER STOP_TOOL_PROBE_CRASH_DETECTION {% if printer.probe.last_que…

X limit for stealthchanger/tapchanger

General Discussion

Sineos November 10, 2024, 2:07pm 2

Attach your log please → How-To Ask for Help

Topic		Replies	Views
Current Klipper logic for max X and Y doesn't seem to make sense and it prevents only the less damaging type of crash Features	9	469	October 9, 2024
Move out of range error / Klipper / Cura General Discussion	5	172	January 23, 2025
No trigger on x after full movement _ General Discussion	11	15856	September 11, 2022
Klipper says "move out of range" on any move General Discussion	8	2992	January 19, 2023
Homing out of range and slams xy endstops General Discussion	5	1480	August 6, 2022

X limit for stealthchanger/tapchanger

Related topics