Basic Information:
Printer Model: Tenlog TL-D3 Pro w/ BIQU H2 Extruders, Running Klipper on BTT CB1.2.
MCU / Printerboard: BTT Octopus Pro v1.0
klippy(2).log (2.7 MB)
printer(7).cfg (11.5 KB)
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
I recently upgraded my motherboard to a Octopus Pro v1.0 and I’m using TMC2209s with sensorless homing, which is necessary for my current wiring configuration.
I cannot get the printer to recognize that it needs to lift the toolhead up to clear the bed and that it will be printing at a higher bed-level than the homed position.
When I perform the Manual leveling, it comments out the position_endstop, which should not be necessary anyway as I’m using virtual endstops via sensorless homing, but the config requires it and sends me error messages if I don’t include it.
When I restore it, I cannot tell it the position_endstop is anything lower than the position_min.
It just wants to print at the homed level.
printer(7).cfg (11.5 KB)
klippy(2).log (2.7 MB)